Society for Testing and Materials (ASTM) methods will be used for .. Provider. From ASTM. D 5 Samples from powder coating lot to. Find the most up-to-date version of ASTM D at Engineering ASTM D Standard Guide for Testing Coating Powders and Powder Coatings.

Author: Mazumuro Vudogor
Country: Zimbabwe
Language: English (Spanish)
Genre: Photos
Published (Last): 19 September 2004
Pages: 457
PDF File Size: 6.84 Mb
ePub File Size: 10.30 Mb
ISBN: 655-1-48385-212-6
Downloads: 63359
Price: Free* [*Free Regsitration Required]
Uploader: Yokora

By design this guide does not purport to address test methods or procedures developed specifically for the functional powder coating market, those coating powders for application to pipe or reinforced steel bars rebar. Many properties of powder coating? It is applicable to both thermoplastic and thermoset coatings, unless indicated otherwise. A superscript epsilon e indicates an editorial change since the last revision or reapproval.

Proceed to Checkout Continue Shopping.

Standard – Standard Guide for Testing Coating Powders and Powder Coatings ASTM D –

Quality is your factory culture, Quickly response is your core! NOTE 2—The recommended sample size of 0.

Allow 60 min for the warm up on the heating bar. Remove the powder quickly and thoroughly before the setting occurs. These conditions may be indicated by the individual test procedure used or agreed upon between the purchaser and seller.

Need more than one copy? D Also, it is recommended that comparisons in arti? Impact resistance has also been found to be a good indication of whether a coating powder has been adequately cured. Determine the susceptibility of a powder coating to? Oxygen Index Apparatus Please first log in with a verified email before subscribing to alerts.

  EN 61241-1 PDF

Standard Guide for Testing Coating Powders and Powder Coatings

Key test methods or practices are as follows: Package Testing Equipment For powder coatings applied to coil strip or blanks, the standard elongation test used is the T-bend. Standards Subscriptions d341 ANSI provides a money-saving, multi-user solution for accessing standards. For the reported hiding power to be signi?

There are many types of abrasion tests available and often one, more than the others, will best simulate the abrasion resistance required in a particular end use application. Adhesion tests can awtm be ast, for testing the degree of attachment between a primer powder coating or other coating type and a second coat of coating powder that is, intercoat adhesion. Selection of the methods to be followed must be governed by experience and the requirements in each individual case, together with agreement between the purchaser and the seller.

Norma ASTM D()

Wire Testing Equipment Interpretation of the test results will depend on the xstm No other units of measurement are included in this standard. The test methods included are listed in Table 1. Common terms associated with optical properties are de?


Impact resistance is dependent on the substrate type and its preparation, the thickness of the substrate, and the? The type, application, and treatment of any undercoat system should be agreed upon between the purchaser and the seller. It should be noted that many of the methods used for characterizing a coating powder, such as gel time Section 16 and inclined flow Section 17are primarily meant for the relative comparison of two coating powders, rather than to give a test value that can be interpreted as good or bad.

Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. The results are highly dependent on such factors as; the pencil type used, the pressure exerted by the operator, and the care taken in preparing the pencil lead.

A powder coatings surface pro? Digital color display A4 print in English optional.

At this time, there is not a recognized ASTM standard test method for determining the cured weight loss for a coating powder; however, the following procedure has proven satisfactory in the?